VW Passat B5

since 1996 release

Repair and operation of the car



Foltsvagen Passat B5
+ Maintenance instruction
+ 1. Maintenance
+ 2. Engines
+ 3. Cooling system
+ 4. Fuel system
+ 5. Engine management
+ 6. Exhaust system
+ 7. Transmission
+ 8. Running gear
- 9. Steering
   9.2. Safety cushion
   9.3. Steering wheel
   9.4. Cross steering draft
   9.5. Installation of the pump of the amplifier of steering
   9.6. Angles of installation of forward wheels
   9.7. Main malfunctions of a suspension bracket and steering
+ 10. Brake system
+ 11. Body
+ 12. Heating, ventilation
+ 13. Electric equipment






9.6. Angles of installation of forward wheels

GENERAL INFORMATION

The angles of installation of wheels considerably influence stability of the car, wear of tires and fuel consumption. Distinguish the following angles of installation of wheels:

Disorder is an inclination of a wheel in the vertical plane of rather average line of the car. It can be positive if wheels are inclined outside or negative if wheels are inclined inside. The disorder corner, generally influences uniformity of wear of tires of forward wheels. If disorder of one wheel positive, and another negative, then takes away the car aside at the movement on a straight line.

Convergence – side distance between wheels. The positive convergence means that wheels are in front located more closely to each other, than behind at measurement at height of an average point of a wheel. The negative convergence means that wheels in front are at bigger distance from each other, than behind.

The cross inclination of an axis of turn of a wheel is a corner between the axis of an inclination of a rotary fist and a vertical which is carried out through a point of fastening of a wheel, looking in the longitudinal direction of the car.

At the expense of corners of disorder and a cross inclination of an axis of turn of a point of a contact of wheels with the road settle down closer to an axis of a rotary fist. It supports a so-called "shoulder of a running in". The "running in shoulder" is less, the driving is easier. Also blows from roughness of a covering are less transferred to steering.

Corner of a longitudinal inclination of an axis of turn. The axis concerning which there is a turn of a wheel is placed in space so that its lower part is inclined forward. Such corner of a longitudinal inclination is called positive. At positive value of a corner self-return of a wheel to average situation after turn improves.

Check and adjustment of angles of installation of wheels need to be made at the station in connection with complexity of the used equipment.