VW Passat B5

since 1996 release

Repair and operation of the car



Foltsvagen Passat B5
+ Maintenance instruction
+ 1. Maintenance
+ 2. Engines
+ 3. Cooling system
+ 4. Fuel system
+ 5. Engine management
+ 6. Exhaust system
+ 7. Transmission
- 8. Running gear
   + 8.1.2. Depreciation rack
   + 8.2. Back suspension bracket
   - 8.3. Wheels and tires
      8.3.2. Instructions on operation of tires
      8.3.3. Check of the gate
      8.3.4. Shift of wheels
      8.3.5. Disks and tires
      8.3.6. Spare wheel
      8.3.7. Replacement of wheels
      8.3.8. Bolty-sekretki for fastening of wheels
      8.3.9. Antisliding chains
      8.3.10. Car raising
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Heating, ventilation
+ 13. Electric equipment






8.3.10. Car raising

GENERAL INFORMATION

Basic spaces for a jack on the Sedan and Station wagon cars


Installation of a jack for a car raising


Prevention

If it is necessary to perform works under the car, for an insurance it is necessary to use supports. Support of the car only one jack is insufficient.

Do not start the engine of the lifted car – it is dangerous.


For a raising of the car it is necessary to use the jack established under basic places of a body of the car which are located approximately in 17 cm from the corresponding wheel arch, see rice. Basic spaces for a jack on the Sedan and Station wagon cars and rice. Installation of a jack for a car raising.
Prevention

If the jack is established not under the basic place of a body, perhaps, damage of a body of the car. Besides, there is a danger of getting injured.


Establish a jack under the car.

The paw of a jack has to cover densely a vertical edge of a longeron in order that when raising the car the jack could not slide off.

At the same time it is necessary to level the provision of a jack and to raise a jack paw until she densely does not lie down to a vertical edge.


Prevention

At installation of a jack on soft soil, perhaps, falling of the car from a jack. Therefore it is necessary to put a jack on solid soil. If it is necessary, it is necessary to use a support, steady and rather big on the area.


For posting of the car it is necessary to use the elevator.

To avoid damages of a bottom of the car, it is necessary to use surely the corresponding linings from the rubberized material.


Prevention

The car cannot be lifted under the oil pallet of a case, under the transmission, under back or forward axes at all, otherwise there can be serious damages of knots and units.


Before entrance on the elevator it is necessary to be convinced that there is a sufficient distance between low-sited points of the car and elements of the elevator.

Elevator paw installation site in a forward part of the car

In a forward part of the car establish a paw of the elevator under the amplifier of the bottom of a body.

Elevator paw installation site in a back part of the car

In a back part of the car establish a paw of the elevator under vertical strengthenings of longerons, in the field of a mark for installation of a jack (1).

The car cannot be lifted in front under vertical intensifying edges of longerons.
купить диплом техникума
купить дипломы грамоты.