Foltsvagen Passat B5 + Maintenance instruction + 1. Maintenance + 2. Engines + 3. Cooling system + 4. Fuel system + 5. Engine management + 6. Exhaust system + 7. Transmission - 8. Running gear + 8.1.2. Depreciation rack - 8.2. Back suspension bracket 8.2.2. Unscrewing of the top fastening of the shock-absorber 8.2.3. Removal and installation of the shock-absorber and spring 8.2.4. Removal and installation of bearings/naves of back wheels + 8.2.5. Depreciation rack of all-wheel drive cars 8.2.6. Check of the shock-absorber 8.2.7. Utilization of the shock-absorber + 8.3. Wheels and tires + 9. Steering + 10. Brake system + 11. Body + 12. Heating, ventilation + 13. Electric equipment
|
Elements of fastening of the hug bearing of a back wheel on front-wheel cars
1 – самоконтрящийся bolt, 35 Nanometers, 2 – support of a back brake, 3 – bolts, 60 Nanometers, 4 – brake disk, 5 – bolts, 60 Nanometers, |
6 – bearing/nave of a back wheel, 7 – tampovanny casing, 8 – back beam, 9 – sensor of rotation of a back wheel, 10 – clamp of the sensor of rotation of a back wheel |
Prevention
At installation of a bolt 1 it is necessary to use a new bolt.
Bearing/nave of a back wheel 6 represent uniform knot. In this case adjustment of the bearing of a back wheel is not required.
Removal
PERFORMANCE ORDER |
|
1. Unscrew two bolts of fastening of a brake support, at the same time, using a thin wrench, hold the directing finger from a provorachivaniye. |
2. Remove brake shoes. |
3. Remove a brake disk. |
|
4. Through an opening in a nave, unscrew five bolts of fastening of the hug bearing of a back wheel. |
5. Remove a bearing/nave of a back wheel. |
|
Installation
PERFORMANCE ORDER |
1. Establish a bearing/nave of a back wheel and screw bolts, having tightened their moment 60 Nanometers. |
2. Establish a brake disk. |
3. Establish brake shoes. |
4. Establish a support of a brake and fix it new самоконтрящимися by bolts, at the same time a thin wrench hold the directing finger from a provorachivaniye. |
|
|
|