Foltsvagen Passat B5 + Maintenance instruction + 1. Maintenance + 2. Engines + 3. Cooling system + 4. Fuel system + 5. Engine management + 6. Exhaust system + 7. Transmission - 8. Running gear + 8.1.2. Depreciation rack - 8.2. Back suspension bracket 8.2.2. Unscrewing of the top fastening of the shock-absorber 8.2.3. Removal and installation of the shock-absorber and spring 8.2.4. Removal and installation of bearings/naves of back wheels + 8.2.5. Depreciation rack of all-wheel drive cars 8.2.6. Check of the shock-absorber 8.2.7. Utilization of the shock-absorber + 8.3. Wheels and tires + 9. Steering + 10. Brake system + 11. Body + 12. Heating, ventilation + 13. Electric equipment
|
Information stated in this subsection belongs to front-wheel cars.
Arrangement of bolts of the top fastening of the back shock-absorber
Elements of the lower fastening of the back shock-absorber
|
1 – nut, 2 – bolt, 3 – shock-absorber |
Removal
PERFORMANCE ORDER |
1. On the car standing on wheels from under the car unscrew bolts of the top fastening of the shock-absorber to a car body (see rice. Arrangement of bolts of the top fastening of the back shock-absorber). For improvement of access to bolts of fastening of the shock-absorber it is possible to raise the car slightly. |
2. For unloading of a spring of a back suspension bracket, lift a back part of the car so that the wheel was raised above the ground on 10 cm. Remove a back spring from support and take it from under the car. If necessary the assistant has to turn a beam of a back suspension bracket down. |
3. Unscrew a nut and take a bolt of the lower fastening of the shock-absorber. Having moved up, take the lower part of the back shock-absorber from a back beam, lower the shock-absorber and take it from under the car, see rice. Elements of the lower fastening of the back shock-absorber. |
|
Installation
PERFORMANCE ORDER |
1. Install the shock-absorber into place, insert a bolt of fastening of the shock-absorber and screw on it a nut, without tightening it it is final. |
2. Establish a spring so that extreme rounds of a spring settled down on support thus, as shown in rice. The correct arrangement of the lower round of a spring in a spring nest. |
3. Screw the top fastening of the shock-absorber on a car body. |
4. Lower the car on the earth so that back wheels were on the earth, but at the same time access to bolts of the top fastening of the back shock-absorber was possible. |
5. Tighten bolts of the top fastening of the back shock-absorber the moment of 45 Nanometers. Tighten a bolt and a nut of the lower fastening of the back shock-absorber the moment of 50 Nanometers and then tighten on a corner 90 °. |
|
|
Разборка зданий посмотреть. Купить съемная тонировка в краснодаре тут.
|