VW Passat B5

since 1996 release

Repair and operation of the car



Foltsvagen Passat B5
+ Maintenance instruction
+ 1. Maintenance
+ 2. Engines
+ 3. Cooling system
+ 4. Fuel system
+ 5. Engine management
+ 6. Exhaust system
+ 7. Transmission
- 8. Running gear
   - 8.1.2. Depreciation rack
      8.1.2.1. Repair of a depreciation rack
      8.1.3. Removal and installation of a power shaft
      8.1.4. Amount of G 000 603 lubricant for external hinges of power shafts
      8.1.5. Lubricant of the internal three-humeral hinge
      8.1.6. Filling of the CV JOINT with G6 lubricant
      8.1.7. Replacement of the internal hinge of equal angular speeds
      8.1.8. Replacement of the external hinge of equal angular speeds
      8.1.9. Dismantling of the external hinge of equal angular speeds
      8.1.10. Malfunctions of power shafts
   + 8.2. Back suspension bracket
   + 8.3. Wheels and tires
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Heating, ventilation
+ 13. Electric equipment






8.1.9. Dismantling of the external hinge of equal angular speeds

GENERAL INFORMATION

As spare parts to the hinge protective covers, washers, lubricant, a nut of a power shaft and spring lock rings are delivered.

PERFORMANCE ORDER
1. Chertilkoy note provisions of a nave and the case of the hinge.
2. Turn a hinge nave in the case and take each sphere. Stack spheres as removal, for the subsequent repeated installation in initial provisions.
3. Turn a hinge separator so that two rectangular cracks were combined with the case, then take a separator and a nave.
4. Turn a nave in a separator so that one of parts of a nave entered one of rectangular cracks in a separator, turn a nave and take it from a separator.
5. Clear all details of the hinge and check their state. If there are wear tracks or corrosion, replace the hinge.
6. Put 45 grams in the hinge case, then install a separator with a nave in the hinge case. Consistently insert spheres into a nave, and check that a nave in a separator and the case were established in a starting position (on earlier made tags). Establish a new lock ring in a nave, then press the remained half of lubricant (45 grams) into the hinge.