Foltsvagen Passat B5 + Maintenance instruction + 1. Maintenance + 2. Engines + 3. Cooling system + 4. Fuel system + 5. Engine management - 6. Exhaust system 6.2. Catalyst 6.3. Operation of cars with the catalyst 6.4. Turbocharger 6.5. Replacement of the muffler 6.6. Oxygen sensor + 7. Transmission + 8. Running gear + 9. Steering + 10. Brake system + 11. Body + 12. Heating, ventilation + 13. Electric equipment
|
The sensor of oxygen is installed in a reception exhaust pipe about the catalyst. On cars with six-cylinder engines two sensors of oxygen are installed.
Removal
PERFORMANCE ORDER |
1. Disconnect the electric socket of the sensor of oxygen which is located on a partition of a motor compartment. Take a sensor electrical wiring from fastening brackets. |
2. Lift the car and fix on supports. |
3. Unscrew the oxygen sensor from a reception exhaust pipe. On cars with engines 1,8-I for a vyvinchivaniye of the sensor of oxygen it is necessary to use VW-3337 key. In the absence of a special key for access to the sensor of oxygen it is necessary to remove a reception exhaust pipe. |
|
Installation
PERFORMANCE ORDER |
1. Apply a thin film of G5 lubricant on an oxygen sensor carving. At installation of the new sensor of oxygen on its carving lubricant is already applied. |
2. Screw in the oxygen sensor in a reception exhaust pipe and tighten its moment 50 Nanometers. |
3. Lower the car on the earth. |
4. Connect the electric socket of the sensor of oxygen and fix a sensor electrical wiring by brackets. Check that there was no contact of an electrical wiring of the sensor of oxygen with a reception exhaust pipe. |
|
|
çàìåíèòü íà ñåàò ðóëåâûå òÿãè
|