VW Passat B5

since 1996 release

Repair and operation of the car



Foltsvagen Passat B5
+ Maintenance instruction
+ 1. Maintenance
+ 2. Engines
+ 3. Cooling system
+ 4. Fuel system
- 5. Engine management
   5.2. Work of a control system of the engine
   5.3. Check of system of injection of fuel
   5.4. Sensors and executive mechanisms of a control system of the engine
   + 5.5. System of ignition
   - 5.6. Fuel highway and fuel nozzles
      5.6.1. Check of fuel nozzles (4-htsilindrovy petrol engine)
      5.6.2. Check of giving of tension to fuel nozzles
      5.6.3. Check of a torch of dispersion and tightness of a fuel nozzle
   5.7. Main malfunctions of a control system of the engine
+ 6. Exhaust system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Heating, ventilation
+ 13. Electric equipment






5.6.3. Check of a torch of dispersion and tightness of a fuel nozzle

GENERAL INFORMATION

Engines 1,6-I AHL

PERFORMANCE ORDER
1. Disconnect the four-contact electric socket from the sensor of temperature of cooling liquid which is located on the thermostat case.
2. Close contacts 1 and 3 sensors with a resistance of 15 Ohms.
3. Remove the fuel highway together with fuel nozzles, without disconnecting from it fuel hoses.
4. Insert fuel nozzles into measuring vessels, for example VAG1602.
5. Ask the assistant to include a starter for several seconds. · During the work of a starter fuel nozzles have to spray fuel. Check a fuel dispersion torch which has to have the cone-shaped form and to be identical at all nozzles.
6. Switch off ignition and check tightness of fuel nozzles. Within 1 minute from fuel nozzles no more than two drops of fuel have to flow out.
7. Install the fuel highway together with fuel nozzles on the engine. Before installation check a state and grease sealing rings of fuel nozzles.
8. Connect the electric socket to the sensor of temperature of cooling liquid.

Engines 1,8-I and 1,6-I ADP

PERFORMANCE ORDER
1. Connect much contact electric socket to the control unit of the ignition coil.
2. Establish the top casing of the engine.