VW Passat B5

since 1996 release

Repair and operation of the car



Foltsvagen Passat B5
+ Maintenance instruction
+ 1. Maintenance
+ 2. Engines
- 3. Cooling system
   3.2. Dolivka of cooling liquid
   3.3. Composition of mix of cooling liquid
   3.4. Replacement of cooling liquid
   3.5. Thermostat
   3.6. Radiator
   3.7. Water pump (engines 1,8-I and 1,6-I ADP)
   3.8. Cooling system hoses
   3.9. Malfunctions of the cooling system
+ 4. Fuel system
+ 5. Engine management
+ 6. Exhaust system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Heating, ventilation
+ 13. Electric equipment






3.7. Water pump (engines 1,8-I and 1,6-I ADP)

GENERAL INFORMATION

Arrangement of bolts of fastening of an arm with the water pump, the generator and viskomufty the radiator fan

Water pump of engines 1,8-I and 1,6-I ADP

1 – cover of the water pump,
2 – laying,
3 – sealing ring,
4 – case of the water pump

Removal

PERFORMANCE ORDER
1. Remove the thermostat.
2. Remove the generator.
3. Take off maple a belt of the drive of the water pump.
4. Unscrew three screws and remove the mechanism of a tension of a poliklinovy belt from an arm.
5. Weaken collars and remove cooling system hoses from the water pump.
6. The arm with the water pump, the generator and viskomufty the fan of a radiator fastens bolts of various length therefore before their unscrewing mark bolts (see rice. An arrangement of bolts of fastening of an arm with the water pump, the generator and viskomufty the radiator fan). Unscrew bolts and remove an arm.
7. Unscrew bolts and remove the water pump from an arm.
8. Turning a shaft of the water pump, check a condition of bearings of the water pump and, if necessary, replace them.

Installation

PERFORMANCE ORDER
1. If the water pump for laying replacement was uncovered, screw a cover bolts, having tightened their moment 10 Nanometers, see rice. Water pump of engines 1,8-I and 1,6-I ADP.
2. Install the water pump with a new sealing ring and an arm on the block of cylinders of the engine and according to earlier put marking screw bolts, having tightened their moment 30 Nanometers. Tighten bolts in a posledov of a telnost of A, B, C, D, E, F, see rice. An arrangement of bolts of fastening of an arm with the water pump, the generator and viskomufty the radiator fan.
3. Install the thermostat.
4. Connect hoses of the cooling system to the water pump and fix them by collars.
5. Install the mechanism of a tension of a poliklinovy belt and fix it by three bolts, having tightened their moment 25 Nanometers.
6. Install the generator.
7. Establish an auxiliary driving belt.
8. Fill in in the cooling system, cooling liquid, and remove air.
9. Start the engine and check tightness of the cooling system.