portable 12v microwave

VW Passat B5

since 1996 release

Repair and operation of the car



Foltsvagen Passat B5
+ Maintenance instruction
+ 1. Maintenance
+ 2. Engines
- 3. Cooling system
   3.2. Dolivka of cooling liquid
   3.3. Composition of mix of cooling liquid
   3.4. Replacement of cooling liquid
   3.5. Thermostat
   3.6. Radiator
   3.7. Water pump (engines 1,8-I and 1,6-I ADP)
   3.8. Cooling system hoses
   3.9. Malfunctions of the cooling system
+ 4. Fuel system
+ 5. Engine management
+ 6. Exhaust system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Heating, ventilation
+ 13. Electric equipment






3.6. Radiator

GENERAL INFORMATION

Removal

PERFORMANCE ORDER
1. Merge cooling liquid from the cooling system.
2. Remove the top fastening of a radiator.
3. If on the car the additional fan of a radiator with the electric drive is installed, disconnect the electric socket from the radiator fan thermal sensor.
4. Disconnect the electric socket from the radiator fan electric motor.
5. Take a radiator fan engine electrical wiring from fastening brackets.
6. Disconnect the top and lower hoses of the cooling system from a radiator.

Cars with the automatic transmission

Arrangement of places of fastening of the heat exchanger of oil of system of the amplifier of steering

PERFORMANCE ORDER
1. Before a rassoyedineniye of pipelines clear connecting couplings of dirt.
2. Disconnect pipelines of supply of oil of the automatic transmission from a radiator. Close the ends of pipelines suitable traffic jams and rags wipe the spilled oil.
3. Unscrew the heat exchanger of oil of system of the amplifier of steering which is located in the lower part of a radiator (see rice. Arrangement of places of fastening of the heat exchanger of oil of system of the amplifier of steering). Do not disconnect pipelines from heat exchangers.

Cars with the air conditioning system
Prevention

Do not disunite hoses of the air conditioning system. Also do not stretch and do not overwind hoses of the air conditioning system.


PERFORMANCE ORDER
1. Unscrew clamps, the fixing pipelines of the air conditioning system.
2. Unscrew the condenser from a radiator and, without stretching hoses, move it forward and enshrine in this provision.
3. Unclench the top clamp of fastening of a radiator.
4. Remove the lower part of a radiator from rubber pillows.
5. Incline a radiator forward and take it together with the electric fan of a radiator.

Check

PERFORMANCE ORDER
1. If the radiator was removed in connection with reduction of capacity, wash out its stream waters in two directions. Outside blow a radiator compressed air.
If the radiator proceeds, do not try to make or solder the place of a leakage since plastic details of a radiator will be damaged.
Insignificant leakage of a radiator can be eliminated with radiator sealant use.
2. Check a condition of the lower rubber support of a radiator and if necessary replace them.

Installation

PERFORMANCE ORDER
1. Check a state and, if necessary, replace rubber pillows of the lower fastening of a radiator.
2. From above establish a radiator together with the electric fan of a radiator.
3. Fix the top part of a radiator by a clamp.
4. At connection of hoses of the cooling system to a radiator use new sealing rings. Connect those hoses of the cooling system to a radiator and fix connecting couplings by the fixing brackets.

Cars with the air conditioning system

PERFORMANCE ORDER
1. Fix the condenser on a radiator.
2. Fix air conditioning system pipelines by the fixing brackets.

Cars with the automatic transmission

PERFORMANCE ORDER
1. Attach to a radiator oil pipelines of the automatic transmission with new sealing rings. Before installation grease sealing rings with liquid for automatic transmissions.
2. Check liquid level in the automatic transmission and, if necessary, bring it to norm.
3. Connect electric sockets to the engine of the fan of a radiator and the thermal sensor. Fix by brackets a radiator fan electric motor electrical wiring.
4. Fill in cooling liquid in the cooling system and remove from it air.
Prevention

At installation of a new radiator it is necessary to fill in fresh cooling liquid.


5. Start the engine and check tightness of the cooling system.
6. Check and if necessary, adjust light of headlights.