VW Passat B5

since 1996 release

Repair and operation of the car



Foltsvagen Passat B5
+ Maintenance instruction
- 1. Maintenance
   1.1. Technical characteristics
   + 1.2. Frequency of service
   + 1.3. Engine oil
   1.4. Check of the exhaust system
   + 1.5. Engine cooling system
   + 1.6. Spark plugs
   1.7. Discharge of water from the fuel filter (diesel engines)
   1.8. Replacement of the fuel filter (diesel engines)
   1.9. Check of tightness of hoses and effluence of liquid
   1.10. Replacement of the filtering element of the air filter
   1.11. Check of a condition of a poliklinovy belt
   1.12. Maple belts
   1.13. Measurement of wear of gear belts on diesel engines
   1.14. Box of transfers / main transfer
   1.15. Check of a protective cover of a power shaft
   1.16. Visual check of tightness of the transmission
   1.17. Check of level of oil in the mechanical transmission
   1.18. Check of oil in the main transfer of automatic transmissions
   1.19. Check/replacement of level of oil in the automatic transmission
   1.20. Check of a forward suspension bracket and steering
   1.21. Check of dustproof covers of hinges of a forward suspension bracket
   1.22. Check of the shock-absorber
   1.23. Check of a radiator
   1.24. Check of electric chains
   + 1.25. Brake fluid
   1.26. Check of front brake shoes
   1.27. Check of back brake shoes
   1.28. Check of brake hoses
   1.29. Check of cables of the emergency brake
   1.30. Check of level of liquid in the amplifier of steering
   1.31. Dust filter
   1.32. Rechargeable battery
   1.33. Hinges of doors
   + 1.34. Windscreen washers
   1.35. Brushes of screen wipers
   1.36. Check of a starting position of the lever of a screen wiper
   1.37. Check of a tilt angle of the lever of a screen wiper
   1.38. Replacement of the battery in a key of remote control
   1.39. Zeroing of the Service-indicator
+ 2. Engines
+ 3. Cooling system
+ 4. Fuel system
+ 5. Engine management
+ 6. Exhaust system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
+ 11. Body
+ 12. Heating, ventilation
+ 13. Electric equipment






1.38. Replacement of the battery in a key of remote control

GENERAL INFORMATION

Prevention

At removal of the battery, check tags about existence of polarity of connection of the battery, otherwise put tags.


Arrangement of a contact plate (1) before its extraction from a head


PERFORMANCE ORDER
1. Using an edge of the thin screw-driver, remove heads from a key.
2. Press clamps from two parties of a head and uncover a head.
3. The screw-driver press a clamp (2) and take the top battery.
4. Take a contact plate, turning it so that two cut-off regions were located opposite to clamps and, using a screw-driver edge, take it from a head, see rice. An arrangement of a contact plate (1) before its extraction from a head.
5. Take the lower battery.
6. Install the lower battery in a head so that the positive pole of the battery was directed down. On a positive pole of the battery there is a sign (+).
7. Install on the battery a contact plate and the top battery by a positive pole down to a zashchelkivaniye of clamps.
8. Establish on a head a cover to a zashchelkivaniye of clamps.
9. Establish and fix a head in a key.