VW Passat B5

since 1996 release

Repair and operation of the car



Foltsvagen Passat B5
+ Maintenance instruction
+ 1. Maintenance
+ 2. Engines
+ 3. Cooling system
+ 4. Fuel system
+ 5. Engine management
+ 6. Exhaust system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
- 11. Body
   11.2. Care of a body
   11.3. Care of an upholstery and rugs
   11.4. Repair of insignificant damages of a body
   11.5. Repair of strong damages of a body
   + 11.6. Forward cross panel
   11.7. Front bumper
   11.8. Removal of the lever of blocking of a cowl
   11.9. Adjustment of the side directing bumper arm
   11:10. Rear bumper
   11:11. Forward wing
   11:12. Facing of a niche of a forward wheel
   11:13. Air inlet lattice
   + 11:14. Cowl
   11:15. Front grille
   + 11:16. Cable of opening of the lock of a cowl
   11:17. Cowl lock
   11:18. Internal finishing of a door
   11:19. Differences at removal of an upholstery of the right forward door
   11:20. Control unit of door mechanisms
   11:21. Consolidation of a door
   11:22. Side finishing of the luggage compartment of the Sedan models
   11:23. Side finishing of the luggage compartment of the Station wagon models
   11:24. Back finishing of the luggage compartment on the Sedan models
   11:25. Trunk lid upholstery
   11:26. Luggage carrier door upholstery
   11:27. A covering of half of the luggage compartment on the Station wagon models
   11:28. Trunk lid
   + 11:29. Luggage carrier lock
   11:30. Adjustment of provision of a cover of a luggage carrier / back door
   + 11:31. The lock of a back door on the Station wagon models
   11:32. Forward door
   11:33. Cylinder of the lock of a forward door
   11:34. External handle of opening of a door
   11:35. Door lock
   11:36. Manual lowering of glass of a door
   11:37. Door glass
   11:38. Door arm
   11:39. Internal rear-view mirror
   11:40. Central console
   11:41. Forward ashtray
   11:42. Back ashtray
   11:43. Decorative overlay of the lever (automatic transmission)
   11:44. Decorative slips under the radio receiver
   11:45. The lower finishing of the dashboard from the driver
   11:46. Ware box
   11:47. Internal decorative overlay of an external rear-view mirror
   11:48. Ceiling handle
   11:49. Antisolar peaks
   11:50. Overlays of thresholds
   11:51. Wind and back flew down
   11:52. Sitting lobbies
   11:53. Head restraint
   11:54. Side safety cushions
   11:55. Back sitting
   11:56. Left back of back sitting
   11:57. Carpet
   11:58. Elements of finishing of an interior
   11:59. External mirror of a back type / glass of a mirror
   11.60. Case of an external mirror
   11.61. Protection / бордюрная roof level
   11.62. Side overlay of a body
   11.63. Replacement of rubber tapes of brushes of screen wipers
   11.64. Nozzles of washers of a windshield
   11.65. Screen wiper levers
+ 12. Heating, ventilation
+ 13. Electric equipment






11:38. Door arm

GENERAL INFORMATION

Arrangement of electric sockets in a forward door


Arrangement of bolts of fastening of the lock and cylinder of the lock of a forward door

1 – bolt of fastening of the cylinder of the lock,
2 – bolts of fastening of the lock,
3 – the aligning door lock bolt,
4 – protective cap

On an arm of a door the door lock, a window regulator and a loudspeaker fasten.

In need of replacement of a window regulator it needs to be replaced together with an arm.

The arm of a door can be removed only when glass of a door is not fixed in window regulator clamps. For this purpose lower door glass to the level of technological openings in an arm and release clamps.

Removal
PERFORMANCE ORDER
1. Remove an internal upholstery of a forward door.
2. Remove the case of the cylinder of the lock of a forward door.
3. Remove technological caps from an arm of a forward door.
4. Lower door glass so that access to glass fastening screws was possible. Weaken screws (2) (see rice. A forward door with the removed door upholstery) also release the clamps fixing door glass.
5. Move door glass against the stop up and, using an adhesive tape, enshrine it in this provision.
6. Disconnect all electric sockets in a forward door, see rice. An arrangement of electric sockets in a forward door).
7. In an end face of a forward door unscrew two bolts fixing the door lock see rice. Arrangement of bolts of fastening of the lock and cylinder of the lock of a forward door.
8. Unscrew the screws fixing an arm to a forward door (see rice. A forward door with the removed door upholstery).
9. Separate the top part of an arm from a door, then raise an arm and, moving it to door hinges, take from a door.
10. Turn an arm and disconnect the electric socket from the door lock.
11. From a reverse side of an arm release brackets, the fixing electric wires.

Installation

Sequence of tightening of screws of fastening of an arm of a door

And – door glass,
In – the screw of fastening of a clamp of glass

PERFORMANCE ORDER
1. In the sequence, to the return to removal, establish an arm at a forward door.
2. Screw in screws of fastening of an arm and tighten the moment 8 Nanometers in a posledov of the telnost presented on rice. Sequence of tightening of screws of fastening of an arm of a door.
3. Remove the adhesive tape holding door glass in the top situation and move glass back to a guide and fix it in clamps and tighten the screw (V) (see rice. Sequence of tightening of screws of fastening of an arm of a door) moment of 10 Nanometers.
4. Further installation is made in the sequence, the return to removal.