VW Passat B5

since 1996 release

Repair and operation of the car

Foltsvagen Passat B5
+ Maintenance instruction
+ 1. Maintenance
+ 2. Engines
+ 3. Cooling system
+ 4. Fuel system
+ 5. Engine management
+ 6. Exhaust system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
- 11. Body
   11.2. Care of a body
   11.3. Care of an upholstery and rugs
   11.4. Repair of insignificant damages of a body
   11.5. Repair of strong damages of a body
   + 11.6. Forward cross panel
   11.7. Front bumper
   11.8. Removal of the lever of blocking of a cowl
   11.9. Adjustment of the side directing bumper arm
   11:10. Rear bumper
   11:11. Forward wing
   11:12. Facing of a niche of a forward wheel
   11:13. Air inlet lattice
   + 11:14. Cowl
   11:15. Front grille
   + 11:16. Cable of opening of the lock of a cowl
   11:17. Cowl lock
   11:18. Internal finishing of a door
   11:19. Differences at removal of an upholstery of the right forward door
   11:20. Control unit of door mechanisms
   11:21. Consolidation of a door
   11:22. Side finishing of the luggage compartment of the Sedan models
   11:23. Side finishing of the luggage compartment of the Station wagon models
   11:24. Back finishing of the luggage compartment on the Sedan models
   11:25. Trunk lid upholstery
   11:26. Luggage carrier door upholstery
   11:27. A covering of half of the luggage compartment on the Station wagon models
   11:28. Trunk lid
   + 11:29. Luggage carrier lock
   11:30. Adjustment of provision of a cover of a luggage carrier / back door
   + 11:31. The lock of a back door on the Station wagon models
   11:32. Forward door
   11:33. Cylinder of the lock of a forward door
   11:34. External handle of opening of a door
   11:35. Door lock
   11:36. Manual lowering of glass of a door
   11:37. Door glass
   11:38. Door arm
   11:39. Internal rear-view mirror
   11:40. Central console
   11:41. Forward ashtray
   11:42. Back ashtray
   11:43. Decorative overlay of the lever (automatic transmission)
   11:44. Decorative slips under the radio receiver
   11:45. The lower finishing of the dashboard from the driver
   11:46. Ware box
   11:47. Internal decorative overlay of an external rear-view mirror
   11:48. Ceiling handle
   11:49. Antisolar peaks
   11:50. Overlays of thresholds
   11:51. Wind and back flew down
   11:52. Sitting lobbies
   11:53. Head restraint
   11:54. Side safety cushions
   11:55. Back sitting
   11:56. Left back of back sitting
   11:57. Carpet
   11:58. Elements of finishing of an interior
   11:59. External mirror of a back type / glass of a mirror
   11.60. Case of an external mirror
   11.61. Protection / бордюрная roof level
   11.62. Side overlay of a body
   11.63. Replacement of rubber tapes of brushes of screen wipers
   11.64. Nozzles of washers of a windshield
   11.65. Screen wiper levers
+ 12. Heating, ventilation
+ 13. Electric equipment

11:32. Forward door

GENERAL INFORMATION

Elements of fastening of a forward door

1 – cap,
2 – bolt of the top hinge of a door,
3 – protective cover,
4 – bolt of the lower hinge of a door,

5 – lower side finishing of a rack of a forward door,
6 – electric sockets

Removal

PERFORMANCE ORDER

1. Remove the lower finishing of a rack of a forward door (5).

2. Disconnect electric sockets (6) on a rack of a forward door.

3. Disconnect from a door rack a protective cover (3).

4. Through an opening (shooter) (see rice. Elements of fastening of a forward door) take electric sockets from a rack of a forward door.

5. On the top hinge of fastening of a door remove a cap (1) and unscrew a bolt (2) fastenings of the top hinge of a door.

6. Unscrew a bolt (4) of the lower fastening of the hinge of a door. At installation it is necessary to use a new bolt of the lower fastening of the hinge of a door.

7. Moving a door up, remove it from hinged loops.

Installation

PERFORMANCE ORDER

1. From above establish a door on hinged loops.

2. Screw in a new bolt of fastening of the lower hinge and tighten its moment 20 Nanometers, then tighten it on a corner 90 °.

3. Screw in a bolt, the fixing top hinge of a door and tighten its moment 25 Nanometers. Establish a cap.

4. Through an opening in a rack of a forward door stretch electric wires and connect electric sockets.

5. Fix a protective cover of wires on a rack of a forward door.

6. Establish internal finishing of the lower part of a rack of a forward door.