VW Passat B5

since 1996 release

Repair and operation of the car



Foltsvagen Passat B5
+ Maintenance instruction
+ 1. Maintenance
+ 2. Engines
+ 3. Cooling system
+ 4. Fuel system
+ 5. Engine management
+ 6. Exhaust system
+ 7. Transmission
+ 8. Running gear
+ 9. Steering
+ 10. Brake system
- 11. Body
   11.2. Care of a body
   11.3. Care of an upholstery and rugs
   11.4. Repair of insignificant damages of a body
   11.5. Repair of strong damages of a body
   + 11.6. Forward cross panel
   11.7. Front bumper
   11.8. Removal of the lever of blocking of a cowl
   11.9. Adjustment of the side directing bumper arm
   11:10. Rear bumper
   11:11. Forward wing
   11:12. Facing of a niche of a forward wheel
   11:13. Air inlet lattice
   + 11:14. Cowl
   11:15. Front grille
   + 11:16. Cable of opening of the lock of a cowl
   11:17. Cowl lock
   11:18. Internal finishing of a door
   11:19. Differences at removal of an upholstery of the right forward door
   11:20. Control unit of door mechanisms
   11:21. Consolidation of a door
   11:22. Side finishing of the luggage compartment of the Sedan models
   11:23. Side finishing of the luggage compartment of the Station wagon models
   11:24. Back finishing of the luggage compartment on the Sedan models
   11:25. Trunk lid upholstery
   11:26. Luggage carrier door upholstery
   11:27. A covering of half of the luggage compartment on the Station wagon models
   11:28. Trunk lid
   + 11:29. Luggage carrier lock
   11:30. Adjustment of provision of a cover of a luggage carrier / back door
   - 11:31. The lock of a back door on the Station wagon models
      11.31.1. Cylinder of the lock of a back door
      11.31.1.1. Arm of the cylinder of the lock of a back door
   11:32. Forward door
   11:33. Cylinder of the lock of a forward door
   11:34. External handle of opening of a door
   11:35. Door lock
   11:36. Manual lowering of glass of a door
   11:37. Door glass
   11:38. Door arm
   11:39. Internal rear-view mirror
   11:40. Central console
   11:41. Forward ashtray
   11:42. Back ashtray
   11:43. Decorative overlay of the lever (automatic transmission)
   11:44. Decorative slips under the radio receiver
   11:45. The lower finishing of the dashboard from the driver
   11:46. Ware box
   11:47. Internal decorative overlay of an external rear-view mirror
   11:48. Ceiling handle
   11:49. Antisolar peaks
   11:50. Overlays of thresholds
   11:51. Wind and back flew down
   11:52. Sitting lobbies
   11:53. Head restraint
   11:54. Side safety cushions
   11:55. Back sitting
   11:56. Left back of back sitting
   11:57. Carpet
   11:58. Elements of finishing of an interior
   11:59. External mirror of a back type / glass of a mirror
   11.60. Case of an external mirror
   11.61. Protection / бордюрная roof level
   11.62. Side overlay of a body
   11.63. Replacement of rubber tapes of brushes of screen wipers
   11.64. Nozzles of washers of a windshield
   11.65. Screen wiper levers
+ 12. Heating, ventilation
+ 13. Electric equipment







11.31.1.1. Arm of the cylinder of the lock of a back door

GENERAL INFORMATION

Elements of fastening of the lock of a back door on the Station wagon models

1 – lock cylinder arm,
2 – nut, 7 Nanometers,
3 – handle plate,
4 – handle,
5 – clips,
6 – deaf nuts,
7 – basis of registration plate,
8 – draft,
9 – lock of a back door,
10 – bolt, 25 Nanometers,
11 – executive engine of system of the central blocking,
12 – executive engine of opening of the lock of a back door,
13 – nut, 7 Nanometers,
14 – lever

Prevention

The cylinder of the lock can be removed from the car only together with an arm 1.

Installation of deaf nuts 6 is made by means of pincers of VW-1765A for a rasklepyvaniye of deaf nuts.


Removal of an arm of the cylinder of the lock of a back door

1 – nuts,
2 – draft

Shooters specified sockets which need to be disconnected.


Use of the screw-driver for a release of a safety bracket

1 – lever

Removal

PERFORMANCE ORDER
1. Remove an internal upholstery of a back door.
2. Disconnect the electric sockets shown by shooters on rice. Removal of an arm of the cylinder of the lock of a back door.
3. Remove draft of the drive of the lock of a back door.
4. Unscrew nuts (1), see rice. Removal of an arm of the cylinder of the lock of a back door.
5. Using a screw-driver edge, unclench a safety bracket and hold it in this situation, see rice. Use of the screw-driver for a release of a safety bracket.
6. Remove from a plate of the handle of a back door an arm with the lock cylinder.

Installation

PERFORMANCE ORDER
1. Record a safety bracket.
2. Insert the lock cylinder into an arm.
3. Establish an arm with the cylinder of the lock on a plate of the handle of a back door and fix them before accurate fixing.
4. Screw nuts (1), see rice. Removal of an arm of the cylinder of the lock of a back door.
5. Establish draft of the lock of a back door.
6. Connect earlier disconnected electric sockets.
7. Establish an internal upholstery of a back door.