VW Passat B5
since 1996 release
Repair and operation of the car
Foltsvagen Passat B5
+
Maintenance instruction
+
1. Maintenance
+
2. Engines
+
3. Cooling system
+
4. Fuel system
+
5. Engine management
+
6. Exhaust system
+
7. Transmission
+
8. Running gear
+
9. Steering
+
10. Brake system
-
11. Body
11.2. Care of a body
11.3. Care of an upholstery and rugs
11.4. Repair of insignificant damages of a body
11.5. Repair of strong damages of a body
+
11.6. Forward cross panel
11.7. Front bumper
11.8. Removal of the lever of blocking of a cowl
11.9. Adjustment of the side directing bumper arm
11:10. Rear bumper
11:11. Forward wing
11:12. Facing of a niche of a forward wheel
11:13. Air inlet lattice
+
11:14. Cowl
11:15. Front grille
+
11:16. Cable of opening of the lock of a cowl
11:17. Cowl lock
11:18. Internal finishing of a door
11:19. Differences at removal of an upholstery of the right forward door
11:20. Control unit of door mechanisms
11:21. Consolidation of a door
11:22. Side finishing of the luggage compartment of the Sedan models
11:23. Side finishing of the luggage compartment of the Station wagon models
11:24. Back finishing of the luggage compartment on the Sedan models
11:25. Trunk lid upholstery
11:26. Luggage carrier door upholstery
11:27. A covering of half of the luggage compartment on the Station wagon models
11:28. Trunk lid
-
11:29. Luggage carrier lock
11.29.1. Trunk lid lock cylinder
11:30. Adjustment of provision of a cover of a luggage carrier / back door
+
11:31. The lock of a back door on the Station wagon models
11:32. Forward door
11:33. Cylinder of the lock of a forward door
11:34. External handle of opening of a door
11:35. Door lock
11:36. Manual lowering of glass of a door
11:37. Door glass
11:38. Door arm
11:39. Internal rear-view mirror
11:40. Central console
11:41. Forward ashtray
11:42. Back ashtray
11:43. Decorative overlay of the lever (automatic transmission)
11:44. Decorative slips under the radio receiver
11:45. The lower finishing of the dashboard from the driver
11:46. Ware box
11:47. Internal decorative overlay of an external rear-view mirror
11:48. Ceiling handle
11:49. Antisolar peaks
11:50. Overlays of thresholds
11:51. Wind and back flew down
11:52. Sitting lobbies
11:53. Head restraint
11:54. Side safety cushions
11:55. Back sitting
11:56. Left back of back sitting
11:57. Carpet
11:58. Elements of finishing of an interior
11:59. External mirror of a back type / glass of a mirror
11.60. Case of an external mirror
11.61. Protection / бордюрная roof level
11.62. Side overlay of a body
11.63. Replacement of rubber tapes of brushes of screen wipers
11.64. Nozzles of washers of a windshield
11.65. Screen wiper levers
+
12. Heating, ventilation
+
13. Electric equipment
11.29.1. Trunk lid lock cylinder
GENERAL INFORMATION
Arrangement of electric sockets (arrow) in a trunk lid
1 – nuts,
2 – draft
Use of the screw-driver for turn of a safety bracket
1 – lock cylinder arm
Removal
PERFORMANCE ORDER
1.
Remove a trunk lid upholstery.
2.
Disconnect electric sockets in a trunk lid, see rice.
An arrangement of electric sockets (arrow) in a trunk lid
.
3.
Disconnect and remove draft of the lock of a luggage carrier (2) cm rice.
An arrangement of electric sockets (arrow) in a trunk lid
.
4.
Unscrew two nuts (1).
5.
The screw-driver counterclockwise turn a safety bracket, see rice.
Use of the screw-driver for turn of a safety bracket
also enshrine it in this provision.
6.
Remove from a trunk lid an arm with the cylinder of the lock (1), see rice.
Use of the screw-driver for turn of a safety bracket.
7.
Remove the lock cylinder from an arm.
Installation
PERFORMANCE ORDER
1.
Using a screw-driver edge, repeatedly wring out counterclockwise a safety bracket (see rice.
Use of the screw-driver for turn of a safety bracket
) also enshrine it in this provision.
2.
Install the lock cylinder in an arm.
3.
Establish an arm with the lock cylinder on a plate of the handle and record it before accurately heard click.
4.
Screw nuts (1) see rice.
An arrangement of electric sockets (arrow) in a trunk lid
.
5.
Connect draft of opening of the lock.
6.
Connect electric sockets.
7.
Establish into place a trunk lid upholstery.